Quadcopter Troubleshooting Strategies and Problem Isolation

※ Download: Ominus quadcopter troubleshooting

Assemble the main gear, propeller shaft, and propeller as shown in this picture to the left. When the trim is centered, the transmitter will emit a long, low pitched beep. A bunch of reusable or regular zip ties the reusable ones are best as you can reuse them, but regular ones work just as well. The Dromida Ominus quadcopter is bright and bold.

The drone itself runs on rechargeable. Full color video and photographs will be crisp and clear, in high definition resolution. For example, if your drone is drifting to the left, press your trim button on the bottom right of the radio controller.

Quadcopter Troubleshooting Strategies and Problem Isolation - You may need new electronics.

Re-link the quadcopter and radio. See Rotor Blade Replacement section. If the quadcopter is constantly drifting in the same troubleshpoting or a new flight control board has been installed, the sensors on the Ominus should be calibrated. Center all the trim adjustments. To check the trim, push the trim button once on one side and then once on the opposite side. When troubelshooting trim is centered, the transmitter will emit a long, low pitched beep. The transmitter will emit a short beep of troubleshooting pitch as the adjustment gets closer to center and higher pitch as the adjustment moves away from center. Continue pressing the trim button that has the lower pitch until the adjustment Ominus centered. Link the quadcopter and the transmitter. Push down on the right stick and hold it. The radio will steadily beep while the stick is held down. Press down on the troubleshooting stick 3 times within 2 seconds.

Dromida Ominus controller or control board issue
They enable you to add or remove flight assistance mode, and to customize your flight plan. Looking at the leading edges of the propeller it should be flat along its entire length the tip curve will be slightly above the leading edge towards the tips. Only clamp on the leading edge, if you clamp too far in you will have to redo the tip curve. The auto-flip button can be flicked to do a pro-style flip quickly. Advanced mode will allow you to take control of the quad, yet still have a bit of help from the gyro technology to keep it stable and in the air. But before you go out and spend money on any parts there are a few things you could try first. Once you know which side is lightest you can add a small piece of tape on the under side of that blade tip. Now the propellers should have the right tip curve and be flat along the leading edges, but we are not done yet. Also check that everything is clean and dry, canned air will clean out most dust. The Dromida Ominus quadcopter has enabled anyone to become a master at quad flying, without requiring a lot of long complicated drone flight school classes first. To change the control sensitivity, you will push down on the right stick and release. You can then move your right stick in any direction, and your drone will flip over.